LIFX Developer Zone

How to activate morph mode in my tiles on LAN Protocol


#1

Hi to everyone!
I was looking for a way to change to morph mode in my tiles in LAN. But there is no information about how to do it.
I read here that the morph mode is in the firmware of the tiles. So, I think, there must be a way to activate it, a specific message to do it.
Could you describe which field and value I have to use to change to this mode?
I can activate/desactivate the tiles and change their colors and I want to change to morph mode or turn them off with an event (a button, a sensor, whatever).
Thanks in advance!


#2

Hi,

You’re correct that there’s a message to turn it on. However we have yet to make that message public.

I’m very confident we will do so eventually!

Unfortunately I’m not aware of when that will be.